Toyota pmn Manuel d'utilisateur télécharger pdf (Page 43)

13. Turbo preparation

1. TURBO PROTECTION.

CAUTION: Cover all the inlet and outlet holes with

protective tape to avoid parts from

falling in.

2. REMOVE PLATE WITH PRESSURE ACTUATOR.

(a) Remove the pressure actuator bracket by removing

the clip and 2 bolts.

R: Clip

R: Bolt (2 pcs.)

R: Pressure actuator.

K: Turbo charger (3-1)

CAUTION: Do not damage nut assurance.

3. TURBO LUBRICATION.

(a) Insert some engine oil into the oil return outlet side of

the turbo and rotate the turbo turbine axle a few times

to lubricate the axle bearings.

CAUTION: Close the inlet hole with tape to avoid

parts from falling in.

4. INSTALL WATER ADAPTERS.

(a) Install the water outlet (2) adapter (16/16mm).

K: Outlet adapter No.1 (17-4)

Torque: 70 Nm

NOTICE: The boss-side of the adapter is facing the

turbo housing side.

(b) Install the water inlet adapter (14/16mm).

K: Inlet adapter No. 2 (16-2)

Torque: 50 Nm

K K

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 63 64

Pas de commentaire

Toyota pmn Manuel d'utilisateur Page 43