Toyota pmn Manuel d'utilisateur télécharger pdf (Page 47)

5. INSTALL TURBO CHARGER BRACKET.

(a) Install the bracket with short bolt and washer to the

engine (hand tighten).

K: Bolt (5-4)

K: Washer (5-5)

K: Bracket (5-2)

(b) Install the bracket with long bolt, washer and spacer to

the Turbo charger (hand tighten).

K: Bolt (5-3)

K: Washer (5-5)

K: Bush (5-6)

6. TIGHTENING TURBO CHARGER.

(a) Tighten the 4 bolts of the Turbo charger.

Torque: 28 Nm

(b) Bend the locking plates against the side of the bolt.

Torque: 20 Nm

(d) Tighten the bolt of the bracket to the engine.

Torque: 16 Nm

7. INSTALL WATER INLET CONNECTION.

(a) Remove the water hose clamps.

R: Hose clamps (2 pcs.)

(b) Remove the water hose.

R: Water hose.

NOTICE: Some coolant will flow out of the cooling

system.

K: Hose Heat Protection. (17-7)

(d) Install hose on turbo inlet side with a clamp.

R: Clamp

Torque: 3 Nm

(e) Install heat protective hose with Lockwire. Use a

stainless steel wire to fit.

K: Hose. (16-3)

NOTICE: Ensure that the clamp is covered by the

sleeve.

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 63 64

Pas de commentaire

Toyota pmn Manuel d'utilisateur Page 47